Auto Restoration Car restoration is a big undertaking


Auto Restoration Car restoration is a big undertaking, but if done right can save you money and give you more customization options. Below is a general overview of the items needed to do the work and your particular job may differ in some respects. Above all you should to carry out these procedures safely while you focus the right protective equipment for themselves and others.

There are seven steps to a basic auto restoration.

Inspection and Evaluation

1) First wash the car allow for a clear view of all surfaces.
2) Make a list of parts required, which can be seen at this time.
3) Make a list of work that can be seen at this time.
4) Make list of needed tools and materials, such as a compressor, air regulator, air hose and hardware, required hand tools and other metalworking tools. Sandpaper and filler will be necessary as well.

Auto Restoration Car restoration is a big undertaking

Dismantling

1) extend to Bill how to disassemble your vehicle.
2) Organize loose parts.
3) Take detailed photos / video of complicated areas before disassembly.
4) Find a safe storage for sensitive parts
5) Do not dispose of parts unnecessarily until the vehicle is ready. This is very important.

Cleaning, insulating and protecting Metal Parts

1) Before stripping be sure tools and materials in place to have the coating, such as: A good rust converter for rust are not removed, and a good primer to protect the metal while the body work is done.
2) Power Sand, sand blast, plastic media blast or chemically strip: Rotary sander should be used with variable speed 1000 RPM.

Have the repairs and filler metal work : Auto Restoration Car restoration is a big undertaking

1) Get. Decent tools like a grinder, stud welder, MIG welder and hand tools
2) If the job is large, focusing on one or two areas at a time.
3) This is the time for filler materials and tools. Use decent filler and sand paper, it is not worth buying cheap products. A dry guide coat is recommended to compensate for the fillers.

Finish the bodywork and start priming: Auto Restoration Car restoration is a big undertaking

1) Polyester Putty is usually the last filler.
2) direct to metal primer then 2K (filler) applied primer.
3) undercoating is done usually before, did finish the painting. Good “direct-to-metal” colors can protect the underside of a deterioration.

Auto Restoration Car restoration is a big undertaking

The painting process

This is one of the main methods of automatic recovery, and takes a lot of preparation and time. If you focus on the restoration of your car plan, definitely look into this process further, as well as the other processes.

Compounding

After waiting on the color to cure something you can sand with ultra fine sandpaper (usually 600 to 2500 grit) to orange peel, dust nibs runs and remove other imperfections. If paint is fully cured, compounding and polishing takes longer, but is less likely to be damaged.

As mentioned earlier, if you are going really to restore your car, hopefully gives you a rough rundown of what you must do, but you should definitely look into it further give you. Comprehensive idea of a complete car restoration

 

Auto Restoration Car restoration is a big undertaking